The newest firmware files can be found in the attachment.


The firmware files currently available are:

NEW! SJCAM_SJ4000PLUS_Firmware_V3.3.bin


Change logs:


V3.3

Introduces the possibility of updating firmware through the SJCAM ZONE App.


V3.2:

1. Available to make future firmware updates through the APP.

---------------------------------------------------------------------------------


V3.1:

1. Increase download speed WIFI connection file

2. Modify the compatibility with the new APP

---------------------------------------------------------------------------------

Change logs in V3.0


Repair interval recording is set for 2 seconds, 1 second a real problem


Warning: Once the SJ4000+ firmware has been updated to Version 2.5 or higher, you cannot flash the SJ4000+ to lower firmware versions. This firmware is only for units with Versions v2.5 and below. If you revert back to a firmware version lower than v2.5 after v2.5 has been installed, you will brick your unit and camera will no longer be functional. 

 

Before the firmware update, please make sure to use a high quality class 10 memory card, a list of supported cards can be found here:

https://sjcamsupport.freshdesk.com/solution/articles/9000005696--what-memory-cards-are-recommended-with-sjcam-cameras-


To upgrade the firmware properly, follow the steps carefully:


Step 1: Please check your current firmware version in the camera settings screen. If your current firmware is v.2.4 or lower, please follow start with step 2, if your current firmware is v.2.5 or newer, please jump to step 3.

 

Step 2: Installing Loader Software:

a) Make sure to reformat the MicroSD card. Note: reformatting is a Must.

b) Drag and Drop software “LD96660A.bin” into the root folder of MicroSD card.

c) Insert microSD card into the SJ4000+ unit and power the camera on. Note: makes sure the camera is off when inserting the card. Once the camera is powered on, turn the SJ4000+ off and remove the card.


Step 3: Installing the firmware:

d) Delete software LD96660A.bin from the MicroSD card. Next, copy v3.1 firmware “SJCAM001.bin” into the root of the microSD. Note: there is no need to root the card again for Step d.

e) Re-insert the MicroSD into the powered off SJ4000+ and power the unit on. It may take 10-15 seconds for the firmware to install. The blue and yellow light will blink until the firmware is installed and then the unit will power on. Check the firmware version to confirm version has successfully been updated then delete file SJCAM001.bin from card otherwise the firmware will re-install upon re-powering the unit on. 



If you have any questions regarding the firmware update, please submit a ticket or email us at support@sjcamhd.com